This will explain
the "uses" of IPC for hackers. Inter-Process Communication
is used for data sharing between applications and computers.
We will be looking at Windows NT default IPC$ share
use for communication between computers. This share
is what we use to start to gain access to the server.
What we will look at before we start is the NET commands
for the console in NT. (Note I was unable to create
a null connection using a 95/98 computer I had to use
an NT computer) The net commands that we will be using
are net use and net view. Now get in to the console
(fake ms-dos) in windows. Pick out your target and make
sure that it is an NT system and it has port 139 open.
You need port 139 open so that net-bios is on. After
checking for that you go to the console and type:
Example 1> C:\>NET USE \\TARGET\IPC$ * /USER:
Example 2> C:\>NET USE \\TARGET\IPC$ * /USER:""
Example 3> C:\>NET USE \\TARGET\IPC$ "" /USER:""
- Note: For some reason the command varies a little
bit from NT to NT
- Note: TARGET is the name or IP of the computer,
ex. \\211.3.4.11\ipc$ * /user:
- Note: If it works youll get> The command completed
successfully.
- Note: To check the connection type NET USE \\TARGET\IPC$
After starting
a null connection you could try to access the hidden
shares. The default hidden shares are: C$, PRINT$, ADMIN$,
IPC$. As you can probably tell shares are hidden by
putting a $ at the end of the share name. Sometime shares
don't have passwords so you can use them. When you create
a null connection you have the least possible rights.
Next you could try using net view. To do this open the
console and type:
Example:
C:\>net view
\\TARGET (Shares)
Or
C:\>net view /workgroup:TARGETWG (Computers in workgroup)
Or
C:\>net view /domain:TARGETD (Computers in domain)
(Note: change TARGETWG
to the name of the workgroup to see all of the computers
connected)
(Note: change TARGET to the IP or name of the computer
to see all none hidden shares)
(Note: change TARGETD to domain name example: /domain:
Bob.com )
If you can't find an open share you could use a program
that I like a lot called winfo. Winfo will get all of
the user names from the target. Or another programs that
is Nat(NetBIOS Auditing Tool). Nat will try names and
passwords (dictionary attack) to get the right one. Another
well like program is sid2user and user2sid.
Last but not least there are DoS attacks that could be
preformed. Dos attacks become outdated quickly but new
ones are always poping up. A good Dos attack that works
on NT systems with printer capibiltes. It kinda goes like
this (null connection is needed): \\target\pipe\spoolss.
Do this alot. The next one is one that im not sure that
works but you fill all the connections possible on: \\target\pipe\samr.
For that I would recomend use a program like ubend.exe
|
