I was just wondering as to why my Netcat [v1.10 NT] doesn't support the "-b allow broadcasts" parameter...
Full Version: Netcatnt 1.10
| QUOTE |
nc: invalid option -- b nc -h for help |
All I can see on my parameter listing (below) is a gap where -b should be...
| QUOTE |
[v1.10 NT] connect to somewhere: nc [-options] hostname port[s] [ports] ... listen for inbound: nc -l -p port [options] [hostname] [port] options: -d detach from console, stealth mode -e prog inbound program to exec [dangerous!!] -g gateway source-routing hop point[s], up to 8 -G num source-routing pointer: 4, 8, 12, ... -h this cruft -i secs delay interval for lines sent, ports scanned -l listen mode, for inbound connects -L listen harder, re-listen on socket close -n numeric-only IP addresses, no DNS -o file hex dump of traffic -p port local port number -r randomize local and remote ports -s addr local source address -t answer TELNET negotiation -u UDP mode -v verbose [use twice to be more verbose] -w secs timeout for connects and final net reads -z zero-I/O mode [used for scanning] port numbers can be individual or ranges: m-n [inclusive] |
Have I just got a dodgy compile...?
Would anyone care to post a -b enabled nc?
Cheers!
-ed.
what does -b does ?
| QUOTE (agamemnon @ Jan 7 2004, 05:51 PM) |
| "-b allow broadcasts" |
tha....
isn't broadcast automatically started with netcat?
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.
